Restraint system control unit data, function - GF82.95-P-3005T

MODEL 211.0/2 with CODE (383) With telephone "Standard" in console on right side of dome with integrated TELEAID emergency call system, hands-free system and antenna with CODE (930) Taxi emergency call with CODE (934) Taxi emergency alarm unit 

The telecommunications control unit (N112) receives the following messages from the restraint systems control unit (N2/7):

• Standby
• Test signal for function check
• Head-on collision, seat belt emergency tensioning retractors activated
• Rear end collision, seat belt emergency tensioning retractors activated
• Head-on collision, airbag deployed
• Side collision, sidebag deployed
• Side collision, windowbag deployed

After TELE AID has been switched on, the telecommunications control unit (N112) awaits an operation readiness message.

If this has not been received even after 30 s, the status display in the SOS switch (S93/3s1) lights up and the fault is entered in the fault memory.

Operation readiness messages arriving later are nevertheless accepted, the status display then goes out again. Once the operation readiness message has been received, the telecommunications control unit (N112) expects additional operation readiness confirmations. If this message is not received for longer than 3 s, the status indicator in the SOS switch (S93/3s1) comes on and the error is stored in the DTC memory of the telecommunications control unit (N112). Later incoming messages are still received A TELE AID emergency call is triggered automatically by the telecommunications control unit (N112) if a crash message is received twice in one second. With a single crash message, the state display in the SOS switch (S93/3s1) lights up. An entry is made in the diagnostic trouble code memory of the telecommunications control unit (N112). Later incoming messages are still received