Programming of control units - AR54.21-P-0014Y

MODEL 129.058 /063 /067 /076, 163, 164, 166, 168, 169, 170, 171, 199, 203, 204, 207, 208, 209, 210, 211, 212, 215, 216, 218, 219, 220, 221, 230, 240, 245, 246, 251, 450, 452, 454, 461.302 /304 /305 /331 /332 /333 /334 /340 /342 /343 /344 /345 /346, 463.206 /208 /209 /232 /233 /240 /241 /243 /244 /245 /246 /247 /248 /249 /250 /254 /270 /271 /303 /306 /308 /309 /322 /323 /332 /333 /336 /340 /341 /346 (except, 245.286) Offline programming with Release CD 

		During the entire work procedure a sufficiently large voltage supply must be provided for the vehicle's on-board electrical system. Otherwise undervoltage damage may occur to the control units.
	Notes on programming control units		AH54.21-P-0001-03Y
1	Connect STAR DIAGNOSIS and start Diagnosis Assistance System (DAS)
	Connect STAR DIAGNOSIS and read out fault memory	Model 129, 163, 164, 166, 168, 169, 170, 171, 199, 203, 204, 207, 208, 209, 210, 211, 212, 215, 216, 218, 219, 220, 221, 230, 240, 245, 246, 251, 461, 463	AD00.00-P-2000-04A
2	Program control unit		AR54.21-P-0014-01Y
3	Perform software calibration number (SCN) coding for control units	Only when required, refer to DAS.	AR54.21-P-0015X
4	Run teach-in procedures	Only when required, refer to DAS.
5	Read out and erase fault memory
6	Disconnect STAR DIAGNOSIS