Synchronizing sliding/pop-up roof, function - GF77.20-P-3002PP

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 203.0 /2 with CODE (414a) Electric glass sliding/pop-up roof

Function

Synchronization must be performed if desychronization has taken place previously.

Performing synchronization

Open the pop-up roof with the roof system switch (N70s1) until the mechanical stop is reached and continue to actuate the roof system switch (N70s1).The overhead control panel control module (N70) continues to actuate the roof system motor (M12m1) and sets the position counter to zero when it has recognized that the roof system motor(M12m1)has been locked up for at least t=0.5 s.

Before reaching the lock-up position, at least 3 edges must have been recognized from Hall sensor 1 (M12b1) and Hall sensor 2 (M12b2)

It is not possible to synchronize the sliding/pop-up roof with the "Convenience opening, convenience closing" and "Automatic opening/closing" features, because these functions are not possible in the desynchronized state.

The sliding/pop-up roof is then in the synchronized state, i.e. the overhead control panel control module (N70) can switch off the roof motor system (M12m1) when the sliding/pop-up roof is being opened/closed in the automatic mode before reaching the mechanical stop.

Desynchronizing sliding/pop-up roof, function

GF77.20-P-3003PP