Desynchronizing sliding/pop-up roof, function - GF77.20-P-3003PP

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 203.0 /2 with CODE (414a) Electric glass sliding/pop-up roof

Desynchronized state

The position of the sliding/pop-up roof is not know. It can be moved in two directions, however, only with the "Open sliding roof" and "Open pop-up roof" buttons on the roof system switch (N70s1).Closing is no longer possible using the roof system switch (N70s1) because it cannot definitely identify the direction of motor rotation. The sliding/pop-up roof is actuated for approx.

t = 0.3 s in the "Open sliding roof" direction to indicate the desynchronized state and protect the mechanical end stop in the position "Sliding roof open". after which the roof system switch (N70s1) must again be pressed in the "open sliding roof" direction.

Desychronization

Desynchronization is accomplished in the following cases:

Voltage at overhead control panel control module (N70) not too high or too low.
Sliding/pop-up roof exceeds defined motion range by 5 motor rotations.
1 of the 2 Hall sensor signals missing for t > 160 ms.
Hall sensor signals missing for t > 160 ms in spite of reversed sliding/pop-up roof.
The defined Hall sensor signal sequence is faulty.
A defect is recognized in the excessive force limitation (pinch protection(M12b3))

In the desynchronized state only the function "Open sliding/popup roof" is possible.

	sliding/pop-up roof obstruction sensor, function		GF77.20-P-3004PP
	Rain closing, sliding/pop-up roof, function	As of 1.6.03 with code (345a) rain sensor Except code (491) USA version Except code (460) Canada vehicles, additional parts	GF77.20-P-2022PP