Remove/install rear door inner door panel - AR72.12-P-0104SXS

MODEL 221.1 with CODE (Z07) Top protection with hydraulic power windows 

Fig 1: Identifying Rear Door Inner Door Panel Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove side window roller blind (2) from left or right rear door		AR72.12-P-2000SXS
2	Disconnect electrical connector from rear door pressure sensor, driver-side (B48/9) or rear door pressure sensor, passenger-side (B48/10)
3	Remove all electrical wiring harnesses fastened to inner door panel (1) from inner door panel (1)	Observe routing for electrical wiring harnesses on inner door panel (1).
4	Disconnect all electrical connectors from left rear door control unit (N69/3) or right rear door control unit (N69/4)
5	Press grommets for electrical wiring harnesses and release cable inward through inner door panel (1)
6	Separate door foil (3) from inner door panel (1)		AR72.12-P-0105SXS
7	Remove bolts (4)		*BA72.12-P-1001-01N
8	Remove inner door panel (1) from rear door	Guide release cable and electrical wiring harnesses through inner door panel (1). Remove electrical wiring harnesses and hydraulic lines in front area of door inner panel (1) at side.
9.1	Remove inner sealing rail (5) from inner door panel (1)	When replacing inner door panel (1).
10.1	Remove rear door pressure sensor, driver-side (B48/9) or rear door pressure sensor, passenger-side (B48/10) from inner door panel (1)	When replacing inner door panel (1). See GOTIS for manual pliers http://gotis.aftersales.mercedes-benz.com
		Rivet 4.8 x 12.70	*BR00.45-Z-1011-13A
11.1	Remove left rear door control unit (N69/3) or right rear door control unit (N69/4) from inner door panel (1)	When replacing inner door panel (1).
			*BA72.12-P-1023-01N
12	Install in the reverse order