Remove/install door foil on rear door - AR72.12-P-0105SXS

MODEL 221.1 with CODE (Z07) Top protection with hydraulic power windows 

Fig 1: Identifying Rear Door Foil Components

Courtesy of MERCEDES-BENZ USA

	Removing
1	Remove side window roller blind (2) from left or right rear door		AR72.12-P-2000SXS
2	Remove splitter protection strips (3) from rear door	Cut through butyl cord on rear of splitter protection strips (3) with suitable blade.
3	Remove mounting anchor (5)
4	Cut through butyl cord on rear of door foil (1) with suitable blade	Cut through butyl cord carefully and carefully separate door foil (1). Otherwise, the paint and seal (4) can be damaged.
	Install
5	Check door foil (1) for damage, replace if necessary	When replacing the door foil (1) remove remains of butyl cord from inner door panel, door lock armor plate and seal (4) and clean bonding surface.
		Cleaner	*BR00.45-Z-1025-04A
6	Inspect butyl cords for damage, replace if necessary	If sections of the butyl cord are damaged, replace only the damaged section. Route new butyl cord parallel to the damaged butyl cord on the door foil (1). Previously clean bonding surface.
		Sealing cord	*BR00.45-Z-1086-01A
		Cleaner	*BR00.45-Z-1025-04A
7	Align door foil (1) on front door and roll on	Ensure that door foil (1) is correctly positioned on front door.
			Figure
8	Install mounting anchor (5)
9	Install splitter protection strips (3)	Coat corresponding screws with thread sealant and tighten in a number of cycles. The butyl cord then settles on the rear.
			*BA72.12-P-1002-01N
		Loctite 577	*BR00.45-Z-1067-01A
10	Install side window roller blind (2)		AR72.12-P-2000SXS

Fig 2: Identifying Roller (168 589 05 63 00)

Courtesy of MERCEDES-BENZ USA