Remove/install rear seat belts - AR91.40-P-0681SXS

MODEL 221.176 with CODE (Z07) Top protection with CODE (Z19) S600 Pullman Guard state sedan Vis-a-vis seat 

Fig 1: Identifying Rear Seat Belts Remove/Install Components (1 Of 6)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Rear Seat Belts Remove/Install Components (2 Of 6)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Rear Seat Belts Remove/Install Components (3 Of 6)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Rear Seat Belts Remove/Install Components (4 Of 6)

Courtesy of MERCEDES-BENZ USA

Fig 5: Identifying Rear Seat Belts Remove/Install Components (5 Of 6)

Courtesy of MERCEDES-BENZ USA

Fig 6: Identifying Rear Seat Belts Remove/Install Components (6 Of 6)

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of injury  caused by release of spring in the automatic belt retractor is released.	Never disassemble automatic belt retractors.	AS91.00-Z-0002-01A
	Risk of injury  caused by performing testing or repair work on airbag or emergency tensioning retractor units.	Store airbag unit with deployment face up, do not subject to temperatures above 100 °C. When working on these units, disconnect the power supply.	AS91.00-Z-0001-01A
	Notes on performing repair, body work and welding on vehicles with airbags and ETR units		AH91.00-P-0002-01M
	Assessment of airbag and belt tensioner units in accident vehicles		AH91.00-P-0006-01B
		Before opening and closing the center door open front and rear door. Center door should be should be slammed, not pushed closed.
	Legal requirements on handling and storing airbags and emergency tensioning retractor units		AH91.00-P-0004-01A
1	Remove rear seat backrest		AR91.12-P-1620SXE
2	Connect ground line to starter battery and to on-board electrical system battery		AR54.10-P-0003SX
3	Mask off insertion tongue (6)	If the seat belt will be reinstalled.
4	Remove trim ring of belt guide (4)
5	Remove heat restraints	Pull head restraint vertically upwards from partition wall cover (5).
6	Remove head restraint guides
7	Remove partition wall cover (5)
8	Remove screw/bolt (1) from belt end fitting (2)	Ensure that belt end fitting (2) is seated properly in its catch.
			*BA91.40-P-1001-01O
9	Remove left and right sealing rail at partition wall window
10	Detach plug-in connection (8)
11	Remove screw/bolt (9) at automatic belt retractor (7)		*BA91.40-P-1006-01O
12	Guide seat belt (3) along partition wall
13	Guide catch (10) of automatic belt retractor (7) out of partition wall (arrow A)
14	Guide automatic belt retractor (7) downward (arrow B)
15	Tilt automatic belt retractor (7) in direction of travel
16	Extend automatic belt retractor (7) downward	Mask off insertion tongue (6) using adhesive tape, as otherwise it may be damaged during installation.
	Notes on disposing of airbag and emergency tensioning retractor units		OS91.00-P-0001-01A
17	Install in the reverse order