Remove/install wheels, rotate if necessary - AP40.10-P-4050RT
Model 251
Left illustration
Right illustration
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Information on tires/rims | AH40.10-P-9411-01A | ||
| Remove | |||
| 1 | Raise vehicle with vehicle lift | ||
| AR00.60-P-1000RT | |||
| 2 | Remove hubcaps | Vehicles with hubcaps | |
| 3 | Unfasten wheel bolts and wheels using wheel lift | ||
| Check | |||
| 4 | Check tires for signs of damage and make sure that they are in good condition | AP40.10-P-4051Z | |
| 5 | Clean and check wheel bolt connection components, then protect against corrosion | AP40.10-P-4050-01A | |
Before mounting a wheel-and-tire assembly all the operation steps listed in the linked description must be conducted carefully. The complete wheel can otherwise work its way loose from the vehicle. |
|||
| Paste, hot lubrication 1 kg, DBL 6879.20 | *BR00.45-Z-1005-06A | ||
| Install | |||
| 6 | Change round wheel-and-tire assemblies on front and rear axles | If necessary, subject to separate repair order and only for vehicles without mixed tires. Maintain running direction of wheel-and-tire assemblies. Otherwise handling characteristics and handling comfort may be impaired and tire wear increased. |
|
| 7 | Mount wheels using wheel lift and tighten wheel bolts | ||
| *BA40.10-P-1001-01J | |||
| 8 | Lower vehicle | ||
| 9 | Correct tire pressure of front and rear axle tires | With CODE 475 (Tire pressure monitor (Siemens)) Only use valve caps made of plastic. There is otherwise a risk of corrosion. In the event of unusual tire pressure loss: ↓ Determine and rectify cause, subject to separate repair order. |
|
| AR40.10-P-1030RT | |||
| 10 | Mount hubcaps | Vehicles with hubcaps Check for correct positioning of hubcap to valve and for correct seating. Otherwise the valve will be damaged or the hubcap will be lost. |
|
| 11 | Activate the tire pressure monitoring system | Only for wheel-and-tire assembly change, tire replacement or a change in tire pressure. | |
| With CODE 475 (Tire pressure monitor (Siemens)) | AR54.30-P-1000-02RTA |
WHEELS
| Number | Designation | Model 251 | |
|---|---|---|---|
| BA40.10-P-1001-01J | Wheel bolt | Nm | 150 |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1005-06A | Paste, hot lubrication 1 kg, DBL 6879.20 | A 000 989 76 51 |