Remove, install poly V-belt - AR13.22-P-1202GZB
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 Mercedes-Benz ML350, 2010 Mercedes-Benz ML350, 2009 Mercedes-Benz ML320, 2009 Mercedes-Benz GL320, and 2008 Mercedes-Benz ML320. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 642.940 in MODEL 164
| Removing | |||
|---|---|---|---|
| Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. | Keep body parts and limbs well clear of moving parts. | AS00.00-Z-0011-01A | |
| 1 | Open engine hood | AR88.40-P-1000GZ | |
| 2 | Remove engine trim panel | AR01.10-P-2405GZB | |
| 3 | Remove engine charge air channel upstream of charge air cooler | AR09.41-P-8623GZB | |
| 4 | Loosen poly-V-belt (1) and remove | Turn tensioning device (2) in the direction "LOOSEN" and lock in place with a drift (3). | |
| Checking | |||
| 5 | Inspect belt pulley sections and tensioning device (2) for damage and dirt | Installation: In the event of damage to the belt pulley or the tensioning device (2), these must be replaced. | |
| 6 | Check poly-V-belt (1) | Installation: In the event of wear and tear or damage, the poly-V-belt (1) must be replaced. | AP13.22-P-1352GZD |
| Check poly-V-belt in visible area for wear | AP13.22-P-1352GZD | ||
| Installing | |||
| 7 | Install poly-V-belt (1) and tighten it. | Turn tensioning device (2) in the direction "LOOSEN" and remove drift (3). The catch is removed and the tensioning device (2) turns itself back into its design position. Do not use belt wax or any similar products. When fitting the poly-V-belt (1), the routing diagram must be observed, see: ↓ |
|
| Routing diagram of poly V-belt | AR13.22-P-3902-02PI | ||
| 8 | Install engine charge air channel upstream of charge air cooler | AR09.41-P-8623GZB | |
| 9 | Reinstall engine cover | AR01.10-P-2405GZB | |
| Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the running engine | Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not grasp hot or rotating parts. | AS00.00-Z-0005-01A | |
| 10 | Carry out engine test run | ||
| 11 | Close engine hood | AR88.40-P-1000GZ |