LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2008 >> GL320 AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - 164 Chassis >> Testing & Repair >> Remove/install rear brake control cable - AR42.20-P-0525GZ

Remove/install rear brake control cable - AR42.20-P-0525GZ

MODEL 164 

Fig 1: Identifying Rear Brake Control Cable Components (1 Of 2)
G05258416Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fig 2: Identifying Rear Brake Control Cable Components (2 Of 2)
G05258417Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
REMOVINGINSTALLING Remove/install    
DANGER Risk of death  caused by vehicle slipping or toppling off of the lifting platform. Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. AS00.00-Z-0010-01A
NOTES Notes on repairs to brake system All models AH42.00-P-0003-01A 
NOTES Notes on self-locking nuts and bolts All models AH00.00-N-0001-01A
1 Release parking brake    
2 Lift/jack up vehicle   AR00.60-P-1000GZ
3 Remove rear wheels.    
REFER TO MAINTENANCE Remove/install wheels, rotate if necessary   AP40.10-P-4050Z
4 Remove left brake disk or right brake disk from rear axle   AR42.10-P-0220GZ 
5 Unhook retracting spring (3) using removal and installation tool SPECIAL TOOL Removal and installation tool Fig 3
6 Remove expanding lock (1) IMPORTANT To do so, open the expanding lock (1) and push out of the rear brake cable (4).
IMPORTANTInstallation:  Grease slide surfaces on expanding lock (1) lightly with MB long-life grease.
 
    Long-life grease *BR00.45-Z-1001-06A 
7 Unclip rear brake cable (4) from wheel carrier (arrows)    
8 Unclip clip (6) from connecting piece (7)    
9 Unclip rear brake cable (4) from connecting piece (7)    
10 Unclip guide (8) IMPORTANT To unclip, squeeze the lock tabs on the guide (8) together.  
11 Squeeze retaining ring (9) together and unclip from bracket together with cable sheathing (5)    
12 Open plastic holder (10) and remove rear brake cable (4) together with cable sheathing (5) NOTESInstallation:  The distance from the plastic holder (10) to the outer tie rod end must be 76 mm and the cable sheathing (5) must not rub against the plastic holder (10) when the brake is in its released state, otherwise the plastic holder (10) could open by itself when the brake is applied or released.  
13 Install in the reverse order    
14 Adjust parking brake   AR42.20-P-0540GZ 
Fig 3: Identifying Removal And Installation Tool (116 589 01 62 00)
G05258418Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
REPAIR MATERIALS

Number Designation Order number
BR00.45-Z-1001-06A Long-life grease A 000 989 63 51