Remove/install windshield washer system pump - AR82.35-P-6002T
MODEL 211.0
MODIFICATION NOTES
| 14.1.04 | Disconnect/connect/remove ground lead from battery |
| Remove/install | |||
| Risk of death cased by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Lift vehicle on lifting platform. | ||
| 2 | Detach right front road wheel | *BA40.10-P-1001-01A | |
| 3 | Remove liner from right front fender | Remove/install inner fender in front fender |
AR88.10-P-1300T |
| 4 | Disconnect electrical connector (1). | ||
| 5.1 | Separate electrical connector (2) | Only on vehicles with Code (600a) headlamp cleaning system |
|
| 6 | Detach washer fluid hose (3) from the window washer fluid pump (M5/1) | ||
| 7 | Unclip bracket (4) from washer fluid reservoir (5) | ||
| 8 | Use a mounting wedge to push off the windshield washer fluid pump (M5/1) from the washer fluid reservoir (5) | ||
| Figure | |||
| 9 | Install in the reverse order | ||
| 10 | Fill washer fluid reservoir (5) | ||
| Check windshield washing unit fluid level, top up if necessary | AP82.35-P-8210N | ||
| 11 | Check windshield washer system for proper function |
WHEELS
| Number | Designation | Model 211 | |
|---|---|---|---|
| BA40.10-P-1001-01A | Wheel bolt | Nm | 130 |