Remove/install side trim panel in rear - AR68.30-P-4780T
WARNING: This page is about a different car, the 2009 Mercedes-Benz E350 and 2008 Mercedes-Benz E350. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 211.2
Shown on left side of vehicle
Shown on left side trim panel
MODIFICATION NOTES
| 8.1.04 | Disconnect/connect/remove ground lead from battery |
| Remove/install | |||
|---|---|---|---|
| 1 | Remove left and right rear seat cushions | AR91.12-P-1020TB | |
| 2 | Fold down left and right rear seat backrest | ||
| 3 | Unclip left and right cover (1) from load compartment side trim panel (1) with mounting wedge | *110589035900 | |
| 4 | Cut stay on load compartment side trim panel (1) at cutting point (arrow) with sharp knife | ||
| 5 | Remove left and right load compartment side trim panel (1) | AR68.30-P-1180T | |
| 6 | Remove left and right trim from C-pillar | AR68.30-P-4490TA | |
| 7 | Unclip door sill molding (2) from rear entrance with mounting wedge | *110589035900 | |
| 8 | Remove expansion clip (3). | ||
| 9 | Fold back floor covering (4) until nut (5) is accessible | ||
| 10 | Unscrew nut (5) | ||
| 11 | Remove edge guard (6) in area of load compartment side trim panel (1) | ||
| 12 | Remove stop (7) from locking eye (8) | ||
| 13 | Remove bolts (9) | ||
| 14 | Unclip load compartment side trim panel (1) at retaining clips (10) from C-pillar with mounting wedge. | ||
| *110589035900 | |||
| 15 | Remove load compartment side trim panel (1) until electrical connector of load compartment socket (X58/4) is accessible. | ||
| 16 | Disconnect electrical connector from load compartment socket (X58/4) and remove load compartment side trim panel (1). | ||
| 17 | Install in the reverse order |