Remove/install trim at C-pillar - AR68.30-P-4490TA
WARNING: This page is about a different car, the 2009 Mercedes-Benz E350 and 2008 Mercedes-Benz E350. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 211.2
Shown on left C-pillar paneling
| Remove/install | |||
|---|---|---|---|
| 1 | Fold right rear seat cushion toward front | ||
| 2.1 | Fold left rear seat cushion toward front | Only when removing left C-pillar paneling (3). |
|
| 3 | Remove screw/bolt (1) and remove belt end fitting (2) | *BA91.40-P-1012-01A | |
| 4 | Fold right rear seat backrest toward front | ||
| 5.1 | Fold left rear seat backrest toward front | Only when removing left C-pillar paneling (3). |
|
| 6 | Loosen edge guard (5) in area of C-pillar paneling (3) | ||
| 7 | Loosen C-pillar paneling (3) with assembly wedge | *110589035900 | |
| 8 | Remove C-pillar paneling (3) and install seat belt (4) | ||
| 9 | Install in the reverse order |
SEAT BELTS/EMERGENCY TENSIONING RETRACTORS
| Number | Designation | Model 211.0 | |
|---|---|---|---|
| BA91.40-P-1012-01A | Bolt, belt end fitting to vehicle floor | Nm | 32 |