Remove/install trunk lid - AR88.50-P-5000SX
MODEL 216, 221
Shown on model 221
| Remove/install | |||
| Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. | Keep body parts and limbs well clear of moving parts. | see AS00.00-Z-0011-01A | |
| 1 | Take off cover (6) | ||
| 2 | Remove hazard warning triangle (5) and bracket (4) | ||
| 3 | Detach umbrella holder (3) | ||
| 4 | Detach hinge bracket trim pieces (2) | ||
| 5 | Detach trunk lid trim (7) | ||
| 6 | Disconnect electrical connectors on wiring harness (8) in trunk lid (1) and remove wiring harness (8) from trunk lid (1) and lay down to side. | ||
| 7 | Unscrew bolts (9) on hinge levers | ||
| 8 | Remove trunk lid (1) out of the hinge levers upwards | ||
| 9 | Install in the reverse order | ||
| 10 | Adjust trunk lid (1) | see AR88.50-P-5200SX |