Remove/install rear spring - AR32.20-P-0230CW: Notes
WARNING: This page is about a different car, the 2011 Mercedes-Benz C300, 2010 Mercedes-Benz C300, 2009 Mercedes-Benz C300, and 2008 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 204, 207
| Remove/install | |||
| Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension | Use only approved tensioning devices; shield off hazard area if necessary. Inspect special tools for damage and proper operation (visual inspection). Wear protective gloves. |
AS00.00-Z-0001-01A | |
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| 1 | Remove rear wheel | ||
| Remove/install wheels | AP40.10-P-4050CW | ||
| 2 | Detach cover of spring control arm (2) | ||
| 3 | Tension rear spring (1) | AR32.20-P-0200-06CW | |
| Figure | |||
| Figure | |||
| 4 | Remove rear spring (1) from spring control arm (2) | ||
| 5 | Install in the reverse order | ||
| 6 | Check headlamp adjustment and correct if necessary | ||
| Check and correct the adjustment of the headlamps | Model 204 | AP82.10-P-8260CW | |
| Model 207 | AP82.10-P-8260EW |