LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2008 >> C350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Wheels, Chassis Alignment Check -- C300 (204.054)) >> Testing & Repair >> Carry out conditions and tests for chassis alignment - AR40.20-P-0260SX

Carry out conditions and tests for chassis alignment - AR40.20-P-0260SX

WARNING: This page is about a different car, the 2011 Mercedes-Benz C300, 2010 Mercedes-Benz C300, 2009 Mercedes-Benz C300, and 2008 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 117, 156, 166, 169, 171, 172, 176, 190, 197, 203, 204, 205, 207, 209, 211, 212, 215, 216, 217, 218, 219, 220, 221, 222, 230, 231, 242, 245, 246 

INSPECT Checking     
1 Check condition of vehicle IMPORTANT For the wheel alignment check all vehicle parts must be installed and the vehicle build completed ready to drive.
The vehicle specified values are provided through the measuring system by means of actual values determined.
The specified tolerances of vehicle specified values are only for the test. If the vehicle is adjusted, the specified values should be aimed for.
 
2 Print out form for wheel alignment check If necessary when an optical chassis alignment is carried out.  
REFER TO FORMS Wheel Alignment Form All except model 197 OF40.20-P-3000-01B 
3 Check tires for wear pattern, tread depth and damage IMPORTANT Perform visual inspection.  
4 Check rims for damage IMPORTANT Perform visual inspection.  
5 Check tire pressure, correct if necessary IMPORTANT See tire inflation pressure chart inside the fuel filler flap.  
6 Check vehicle underside for damage, corrosion of suspension parts, chassis parts and supporting body parts, leaks from major assemblies and lines IMPORTANT Perform visual inspection.  
7 Raise front axle and check wheel bearing play without dial indicator    
8 Check condition of steering mechanism IMPORTANT Check tie rods, tie rod ball joints and steering coupling.  
Model 204 AP46.00-P-4653CW
9 Check front axle ball joints for play and check dust boots for damage   AP33.20-P-3353CW
10 Check rear axle ball joints for play and check dust boots for damage    
11 Check condition of shock absorbers and check springs for damage    
12 Drive the vehicle onto the measuring station and secure using the parking brake    
13 Unlock turnplates and sliding platforms    
14.1 Raise vehicle level and then lower again Vehicle with Active Body Control (ABC) or air suspension.  
14.2 Rock vehicle to settle suspension on front and rear axles several times Vehicle with steel suspension.