Rear end damage, center - AR64.20-P-1250RT

MODEL 251 

Fig 1: Identifying Rear End Damage And Center

Courtesy of MERCEDES-BENZ USA

	Remove
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	Risk of death  caused by high voltage used for arc welding. Risk of explosion  caused by welding in the area of highly inflammable materials. Risk of injury  caused by welding spatter and UV-light while welding. Risk of poisoning  caused by inhaling welding vapors.	Use insulating mats. Wear protective clothing, safety glasses and protective mask. Remove highly inflammable materials from the danger zone. Use air extractor.	AS00.00-Z-0007-01A
	General information on body repair	All models	AH60.00-N-0001-01A
1	Remove detachable body components in the repair area
2	Cover detachable body components remaining in vehicle (area to be repaired).	Tarpaulin (fire-resistant)	*WH58.30-Z-1001-40A
3	Set up straightening bench and position vehicle on straightening bench	Use straightening bench to repair center rear end damage	AR60.10-P-1060RT
4	Remove rear crossmember		AR64.20-P-1100RT
5	Remove spare wheel well		AR64.20-P-1245RT
	Install
6	Install spare wheel well		AR64.20-P-1245RT
7	Install rear crossmember		AR64.20-P-1100RT
8	Remove vehicle from straightening bench		AR60.10-P-1060RT
9	Clean repair areas
10	Prime area to be repaired with priming filler	.
11	Perform seam sealing after repair		AR97.10-P-4000RT
12	Paint repair areas and adjacent surfaces	.
13	Apply additional cavity preservation		AR97.20-P-1500RT
14	Reinstall all detachable body components removed

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1001-40A	Tarp (fire-resistant)