Remove/install front prefuse box - AR54.15-P-1330RT
MODELS 251
Shown on vehicle with engine 113.971
Fig 1: Identifying Front Pre-Fuse Box Remove/Install Components - Shown On Vehicle With Engine 113.971
| Remove/install | |||
| Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. |
AS54.10-Z-0001-01A | |
| Notes on battery | All models | AH54.10-P-0001-01A | |
| 1 | Disconnect battery ground cable | AR54.10-P-0003RT | |
| 2 | Open engine hood and raise to vertical position | AR88.40-P-1000RT | |
| 3 | Place protective cover on the left front fender | ||
| 4 | Remove plastic cover (1) for nut (2) | ||
| 5 | Unscrew nut (2) and remove positive lead (3) | *BA54.15-P-1001-01E | |
| 6 | Detach front prefuse (F32) from side of engine compartment | ||
| 7 | Detach cover (4) from front prefuse (F32) | ||
| 8 | Unscrew nuts (5) and remove lines (6) | ||
| 9 | Remove front prefuse (F32) | ||
| 10 | Install in the reverse order | ||
| 11 | Perform basic programming | AR00.19-P-0200RT |
FUSE AND RELAY BOX
| Number | Designation | Model 251 | |
|---|---|---|---|
| BA54.15-P-1001-01E | Nut, electrical line (positive lead) to fuse and relay box | Nm | 12 |