| |
Adjust |
|
|
| 1 |
Set time on instrument cluster |
See Operator's Manual |
|
| 2 |
Normalizing power windows |
- Close all doors and switch on the ignition.
- Using the switch move each window to the upper end position. In this position press each switch in the power window and outside mirror adjustment switch group, driver (S20/1) for at least 1 s.
The normalization of the power windows procedure is also available in the operator's manual. |
|
| 3 |
Normalize the power glass tilting/sliding roof |
Only vehicles with power glass tilting/sliding roof, code 414.
- Switch on ignition.
- Use switch to move power glass tilting/sliding roof to raised position, until the maximum raised position is reached. Keep the switch pressed when in this position for approximately one second.
- Actuate the express function (as described in the operator's manual) by briefly pressing the switch (beyond point of resistance). If the power glass tilting/sliding roof is then fully opened, the normalization was successful. If necessary, repeat the procedure.
The normalization of the power glass tilting/sliding roof procedure is also available in the operator's manual. |
|
| 4 |
Normalize 3rd seat row power windows |
If installed.
See Operator's Manual |
|
| 5 |
Calibrating the compass |
If installed.
See Operator's Manual |
|