Retrofit CD changer - AN82.64-P-0001RT

MODEL 251 up to 30.6.07 except CODE (808) Model year 2008 

Fig 1: Identifying Retrofit CD Changer Components

Courtesy of MERCEDES-BENZ USA

	Remove
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Remove radio		AR82.60-P-7502RT
2	Remove glove box (1)		AR68.10-P-1400RT
3	Remove paneling in right footwell		AR68.30-P-4010RT
4	Unclip cover (5)	The cover (5) is no longer required.
		Long wedge	Fig 2
5	Expose predetermined fracture point (6) for CD changer release button
	Install
6	Retrofit wiring harness of fiber optic cable for the Media Oriented System Transport (MOST) AN82.61-P-0001-06GZ
	Wiring diagram for MOST bus		PE82.00-P-2710RAA
	Notes on avoiding damage to optical fibers during repair work	With Media Oriented System Transport (MOST)	AH82.60-P-0001-05AK
7	Mount CD changer (A2/6) to bracket (3) with screws (4)
8	Fasten bracket (3) and CD changer (A2/6) to dashboard support with screws (2)
9	Insert electrical connector for Media Oriented System Transport (MOST) (7) and electrical connector for mains cable (10) of CD changer into Instrument panel wiring harness (arrow)
10	Attach release mechanism (8) to glove compartment	Ensure that spring (9) is installed correctly.
11	Install remaining parts
12	Connect Star Diagnosis
13	Carry out variant coding with the Diagnosis Assistance System by means of Software Calibration Number (SCN)	Log in CD changer (A2/6) and configure MOST ring again.
14	Enter special equipment in the vehicle data card and in the vehicle's online data card	Enter the code consisting of the letter and number combination "ETN819" for the CD changer (A2/6).
15	Disconnect Star Diagnosis
16	Conduct function test of CD changer (A2/6)
17	Document retrofitted equipment using vehicle documentation (VeDoc)	Attach "CD changer retrofitted, as per AN82.64-P-0001RT " note under the field organization texts to design group 82

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA