Remove/install front door lining - AR72.10-P-1000RT

MODEL 251 

Fig 1: Identifying Front Door Lining Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Front Door Lining Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/Install
1	Open front door
2	Completely move down window
3	Switch off ignition and remove the transmitter key from the EIS [EZS] control unit	On vehicles with Keyless Go, code 889: Press keyless go start/stop button repeatedly until ignition is switched off Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).
4	Remove mirror triangle cover (2)		AR72.10-P-3001RT
		Mounting wedge	Fig 3
5	Remove left interior CL switch(S85/5) or right interior CL switch (S85/6) from door lining (1)	Removal:  Actuate both central locking buttons simultaneously and pull lug visible between central locking buttons.
6	Unscrew bolt (4)
7	Pry off door lining (1)	Removal:  First position mounting wedge at bottom of door lining (1) and then at side on door lining (1). Removal:  Position mounting wedge directly to clips (arrows) Check clips and replace if necessary
		Mounting wedge	Fig 3
8	Remove door lining (1) upward from door	Removal:  Carefully remove door lining (1) to prevent damage to ribbon cables. Slide mount (7) onto bracket (8) from top
9	Remove Bowden cable (6) from inner door opener
10	Separate electrical connectors (5)	Treat ribbon cables carefully to prevent damage
11	Remove door lining (1)
12	Install in the reverse order

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA