Remove/install compensator control unit - AR82.70-P-0030GZ

MODEL 164.1 with CODE (388) "Portable CTEL" UPCI telephone system 

Fig 1: Identifying Compensator Control Unit Components Location

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/Install
	Notes on avoiding damage to electronic components due to electrostatic discharge	All models	AH54.00-P-0001-01A
1	Switch off ignition and remove the transmitter key from the EIS control unit
2	Remove paneling (2) at side in load compartment		AR68.30-P-4800GZ
3	Unclip cover (4)
4	Detach trim (3) from C-pillar	Undo 3 bolts (arrows) and carefully detach trim from clips. Place trim to one side, but do not completely remove.
		Mounting wedge	Figure
5	Detach antenna cable connectors (5, 8) and electrical connector (7)
6	Undo four screws (6) and remove compensator control unit (1)
7	Install in the reverse order

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.