Remove and install COMAND operating, display and controller unit - AR82.85-P-1000T
MODEL 211.0/2/6 with CODE (512) COMAND APS with DVD changer with CODE (526) COMAND (without navigation) with CODE (527) COMAND APS (with navigation) with CODE (527) COMAND APS with single DVD drive (with navigation)
| Remove/install | |||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Transfer basic data of COMAND operating, display and controller unit (A40/3) to STAR DIAGNOSIS | When replacing the COMAND operating, display and controller unit (A40/3). |
|
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A | ||
| 2.1 | Remove center stowage compartment and place to one side with electrical lines still connected | Vehicles up to 1.6.08 without code (809) Model year 2009 without code (819) CD changer |
AR68.10-P-1620T |
| 2.2 | Remove holder with CD changer and place to one side with electrical lines still connected | Vehicles up to 1.6.08 without code (809) Model year 2009 with code (819) CD changer |
AR82.64-P-7508T |
| 2.3 | Remove upper control panel control unit holder and place to one side with electrical lines still connected | Vehicles as of 2.6.08 Vehicles with code (809) Model year 2009 |
AR54.21-P-1262TY |
| 3 | Unscrew bolts (1) counterclockwise as far as to the stop | ||
| 4 | Pull COMAND operating, display and controller unit (A40/3) out of the center console until the fiber optic cable connector and the electrical connectors at the rear of the COMAND operating, display and controller unit (A40/3) are accessible | ||
| 5 | Disconnect fiber optic cable connector and electrical connectors at the rear of the COMAND operating, display and controller unit (A40/3) and remove COMAND operating, display and controller unit (A40/3) | ||
| 6 | Cover fiber optic cable | AR82.95-P-0005-01A | |
| 7 | Install in the reverse order |