Remove/install front prefuse box - AR54.15-P-1330TX

MODEL 219.3 

Fig 1: Identifying Front Pre-Fuse Box Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Front Pre-Fuse Box Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Move front passenger seat towards the rear	See Operator's Manual
2	Disconnect battery ground line		AR54.10-P-0003TX
3	Remove bottom rear engine compartment paneling		AR61.20-P-1105TX
4	Remove cover plate (1)
5	Clip on protective cap (2)
6	Unscrew nut (3) and remove the electrical line (4)	Replace self-locking nut (3).
7	Lower the vehicle with the lifting platform
8	Fold back floor covering (5) in passenger footwell
9	Remove damping material (6) upwards off the footrest (8)
10	Unscrew nuts (7)
11	Remove footrest (8) and put down in front passenger footwell
12	Remove support (9)
13	Detach supply lines (10) on the front prefuse box (F32) and place the supply lines (10) to one side	The nuts remain on the supply lines (10). The color codings of the supply lines (10) must match the color codings on the front prefuse box (F32).
			*BA54.10-P-1009-01C
14	Detach positive line (11) on the front prefuse box (F32) and place positive line (11) to one side		*BA54.10-P-1002-01C
15	Unclip fuse holder (12) at the front prefuse box (F32)	Number of fuse holders (12) depending on equipment. The color codings on the fuse holder (12) must match with the color codings on the front prefuse box (F32).
16	Unscrew nut (13)
17	Unscrew nut (14) and remove front prefuse box (F32)		*BA54.10-P-1009-01C
18	Install in the reverse order

BATTERY

Number	Designation			Model 219.3
BA54.10-P-1002-01C	Nut, terminal 30 in prefuse box		Nm	7
BA54.10-P-1009-01C	Nut, line connection to front prefuse box	M6	Nm	7
		M8	Nm	-
BA54.10-P-1023-01C	Nut, power connection circuit 30 to front prefuse box	M8	Nm	14