Remove/install paneling on B-pillar - AR68.30-P-4700TX

MODEL 219.3 

Fig 1: Identifying Paneling On B-Pillar Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Paneling On B-Pillar Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove
1	Position seat toward front and move rear seat surface upward
2	Remove cover (1) from front seat
3	Remove belt end fitting (2) from front seat
4	Remove paneling from outer B-pillar		AR88.80-P-8550TX
5	Remove front and rear entrance paneling		AR68.30-P-4100TX
6	Remove front and rear edge guard (3) in area of B-pillar paneling (4)
7	Loosen rear window seal (5) in area of B-pillar paneling (4)
8	Press B-pillar paneling (4) off of retaining clips (6) with mounting wedge in direction of passenger compartment		Figure
9	Remove retaining clips (7) on B-pillar paneling (4) from B-pillar with suitable screwdriver	Avoid damage to B-pillar
10	Move seat belt (8) through B-pillar paneling (4)
11	Remove B-pillar paneling (4)
	Install
12	Install retaining clips (6) on B-pillar
13	Install retaining clips (7) on B-pillar paneling (4)
14	Move seat belt (8) through B-pillar paneling (4)
15	Install guides (11) of B-pillar paneling (5) below headliner
16	Clip B-pillar paneling (4) into retaining clips (6) on B-pillar	Insert bolt mount (9) into bolt (10) Ensure that retaining clips (6) are seated properly.
17	Check function of belt height adjustment on B- pillar	It should be possible to adjust and arrest the belt height adjustment.
18	Clip retaining clips (7) on B-pillar paneling (4) into B-pillar (4)	Ensure that retaining clips (7) are seated properly.
19	Moisten rear window seal (5) with lubricant in area of guide (arrow) and position with mounting wedge	The mounting wedge should not have sharp edges
			Figure *BR00.45-Z-1010-06A
20	Install front and rear edge guard (3) on B-pillar
21	Install front and rear scuff plate		AR68.30-P-4100TX
22	Install belt end fitting (2) on front seat		*BA91.40-P-1001-01M
23	Install covering (1) on front seat
24	Install paneling outer B-pillar		AR88.80-P-8550TX

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		Model 219
BA91.40-P-1001-01M	Bolt to front seat belt end fitting	Nm	32

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1010-06A	Lubricant, rubber assembly 1 l	A 000 989 03 67