Remove/install/disassemble rear shelf - AR68.30-P-4580Q

MODEL 209.3 with CODE (540a) Electric roller blind for rear window 

Fig 1: Identifying Rear Shelf Components

Courtesy of MERCEDES-BENZ USA

	Remove/Install
1	Unscrew nuts (1)
2	Unclip covers (2)
3	Release rear seat backrest and fold forward	See Operating Instructions
4	Unhook locking controls (3) in trunk from the rear seat backrest lock.
5	Remove paneling on C-pillar		AR68.30-P-4490Q
6	Remove rubber buffer
7	Remove spreading clips
8	Lift rear shelf (5) until electrical connector (6) is accessible
9	Unplug electrical connector (6)
10	Take out rear shelf (5) with roller blind (7)
11.1	Loosen electric lead (8) from rear shelf (5)	Only when replacing rear shelf (5)
		Installation:  Fasten electric lead (8) to rear shelf (5) with strips of adhesive tape.
12.1	Slacken nuts (9)	Only when replacing rear shelf (5)
		Installation:  Carefully screw on nut (9) by hand to prevent damaging rear shelf (5)
13.1	Remove roller blind (7)	Only when replacing rear shelf (5)
		Installation:  Slide roller blind (7) up to stop into guides (10)
14	Install in the reverse sequence