SRS warning lamp illuminated and DTC B1035, B1036 and/or B103B, B1039 stored in retaining system control unit - AF91.60-P-8060A
MODEL 203
MODIFICATION NOTES
| 21.11.04 | Beginning immediately, it is no longer necessary to return the connector subject to complaint | AF91.60-P-8060-01A |
OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES
| Category | Op. no. | Operation text | Time | Acc. no. | Code |
|---|---|---|---|---|---|
| P | 024022 | Remove connectors from the wires for sidebags in left and right front footwells and left and right rear entry ways and connect wires directly | 034 WU | - | - |
| P | 024124 | Disconnect connector for sidebag in front footwell at entrance on left and right and connect leads directly | 018 WU | - | - |
| Damage code | Cause | Remedy | |
|---|---|---|---|
| 59 485 74 | The resistance in R12/11, R12/12, R12/20 or R12/21 ignition circuits for the sidebag squibs is too high. Left front door separation point (X35/1), right front door separation point (X35/2), left rear door separation point (X35/3) or left right door separation point (X35/4) are faulty. | ||
| 1 Withdraw ignition key. | |||
| 2 Remove paneling from A pillar in footwell and door sill molding. ↓ |
|||
| Remove front floor covering (left) | AR68.20-P-2050P | ||
| Remove front floor covering (right) | AR68.20-P-2070P | ||
| 3 Remove rear door sill molding (right and left). | |||
| 4 Expose wiring harness. | |||
| PE91.60-P-2101FA | |||
| 5 Remove connectors and connect wires directly with solder connectors. | AF91.60-P-8060-01A | ||
| Figure | |||
| Heat gun | *WH58.30-Z-1004-20A | ||
| 6 Erase fault code memory with STAR DIAGNOSIS. | |||
| 7 Install in reverse sequence. |
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation |
|---|---|
| WH58.30-Z-1004-20A | Hot-air gun |
PARTS ORDERING NOTES
| Part no. | Designation | Quantity |
|---|---|---|
| 002 546 13 41 | Solder connector | 16 |
| 230 540 58 05 | Repair kit | 2 |