Connect wires Repair wiring harness using solder connectors - AF91.60-P-8060-01A

MODIFICATION NOTES

12.7.04

Beginning immediately; it is no longer necessary to return the connector subject to complaint.

Fig 1: Identifying Wiring Harness Repair Kit (220 589 02 99 00)

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1004-20A	Hot-air gun

1. Separate line approx. 10 mm in front of and behind connector.
2. Remove about 20 mm of fabric tape on the control unit side.
3. Strip approx. 15 mm of electrical lines
4. Slide solder connector onto electrical lines
5. Twist both wire ends together.

   Observe wire color assignment!

6. Position solder connection in center and shrink with heat gun (solder)
7. Check solder connections.
8. Tape up both ends of the wires.