| 1.1 |
Remove rear section on bottom of soundproofing |
Vehicles with diesel engines |
AR94.30-P-5300T |
| 1.2 |
Remove rear part section of engine compartment paneling |
Vehicles with gasoline engine |
AR61.20-P-1105T |
| 2 |
Remove crossmember (35) |
 |
*BA62.30-P-1001-01A |
| 3 |
Detach heat shields (105d, 105e) and slide back or remove |
Depending on accessibility |
|
| 4 |
Preload automatic slack adjuster (91) |
|
AR42.20-P-0520-01A |
| 5 |
Detach front brake cable (85) at automatic cable slack adjuster (91) |
 Installation:
to attach front brake cable (85): ↓ |
|
| |
|
Pre-tension automatic cable slack adjuster (91) again.
Installation:
after attaching front brake cable (85): ↓ |
AR42.20-P-0520-01A |
| |
|
Slacken automatic cable slack adjuster (91) |
AR42.20-P-0520-02A |
| 6 |
Remove retaining clip (85a) at propshaft tunnel |
Installation:
Replace retaining clips (85a). |
|
| 7 |
Unclip front brake cable (85) from bridge (70) |
 |
Figure |
| 8 |
Remove front left floor covering |
|
AR68.20-P-2050T |
| 9 |
Remove retaining clip (85a) in driver footwell |
Installation:
Replace retaining clips (85a). |
|
| 10 |
Remove supporting wedge (17) |
|
|
| 11 |
Detach front brake cable (85) from tensioning shackle (85b) |
Installation:
Pay attention to the correct position of the rubber ring (85c) in the tensioning shackle (85b). |
|
| 12 |
Unclip front brake cable (85) from pedal assembly (71) |
|
Figure |
| 13 |
Lever rubber grommet (85d) out of propshaft tunnel and pull front brake cable (85) into passenger compartment |
Installation:
Feed the front brake cable (85) through from passenger compartment outwards. |
|
| 14 |
Install in the reverse order |
|
|
 |
Checking |
|
|
| 15 |
Check pedal travel at parking brake pedal; adjust parking brake if necessary |
|
AR42.20-P-0540T |