LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2006 >> CLK55 >> Repair and Diagnosis >> External Pages >> Different car >> Section 324 (Interior Equipment -- CLK350 Coupe (209.356)) >> Testing & Repair >> Remove/install instrument panel lower section on driver side - AR68.10-P-1505Q

Remove/install instrument panel lower section on driver side - AR68.10-P-1505Q

WARNING: This page is about a different car, the 2009 Mercedes-Benz CLK350 and 2008 Mercedes-Benz CLK350. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 209 

Shown on vehicle with code 352 COMAND operating and display system 

Fig 1: Identifying Driver Side Instrument Panel Lower Section Components
G07718814Courtesy of MERCEDES-BENZ USA
MODIFICATION NOTES

23.1.04 "Disconnect/connect battery ground line" removed
REMOVINGINSTALLING Remove/install     
1 Remove center console Model 209 without code P98 Black Series AR68.20-P-2000Q 
Model 209 with code P98 Black Series AR68.20-P-2000QBS 
2 Remove center console cover (3)   AR68.20-P-2350Q 
3 Remove instrument cluster   AR54.30-P-6015P
4 Remove light switch module (S1)   AR54.25-P-3270P
5.1 Loosen COMAND operating, display and controller unit (A40/3) up to 31.5.04
with code 352 COMAND operating and display system, with code 498 Japanese version
AR82.85-P-7472Q
as of 1.6.04
with code 498 Japanese version, with code 527 COMAND APS (with navigation), with code 530 COMAND APS USA (with navigation)
IMPORTANT Position COMAND operating, display and controller unit (A40/3) so that bolts on driver-side instrument panel section are accessible.
IMPORTANT Do not unplug connectors.
AR82.85-P-7472QA
5.2 Loosen radio up to 31.5.04
with code 756 Radio MB Audio 10 CD with VK/RDS
AR82.60-P-7502Q
as of 1.6.04 AR82.60-P-7502QA
up to 31.5.04 with code 353 Audio 30 APS AR82.61-P-7412P
as of 1.6.04 with code 525 Radio MB Audio 50 APS
IMPORTANT Position radio so that bolts on instrument panel lower section on driver side are accessible.
IMPORTANT Do not unplug connectors.
AR82.61-P-7412QA
6 Remove bolts (4)    
7 Remove cover below instrument panel on left with lines connected and hood release cable hooked in    
8 Unscrew trim ring from EIS control unit (N73) SPECIAL TOOL Claw wrench Fig 3
9 Unclip instrument panel lower section (1) on driver side and remove. SPECIAL TOOL Mounting wedge Figure
10 Unhook release cable for foot-operated parking brake from operating lever    
11 Remove EIS control unit (N73) from instrument panel lower section on driver side (1)    
12 Install in the reverse order    
Fig 2: Identifying Mounting Wedge (110 589 03 59 00)
G07718815Courtesy of MERCEDES-BENZ USA
Fig 3: Identifying Claw Wrench For Trim Ring On Ignition/Starter Switch (210 589 00 07 00)
G07718816Courtesy of MERCEDES-BENZ USA