Remove/install floor covering in rear - AR68.20-P-4800PB

MODEL 203.7, 209.3 /4 

Shown on model 203.7 

Fig 1: Identifying Floor Covering In Rear Remove/Install Components - Model 203.7, 209.3 /4

	Remove/Install
1	Remove front seats (1)	Model 203	AR91.10-P-1000P
		Model 209	AR91.10-P-1000Q
2	Remove center console (2)	Model 203	AR68.20-P-2000P
		Model 209	AR68.20-P-2000Q
3	Remove rear seat cushion (3).	Models 203, 209.3 Only loosen rear seat cushion (3) at front and slide toward rear	AR91.12-P-1020P
		Model 209.4 Remove left and right rear seat cushions (3)	AR91.12-P-1700QA
4.1	Remove stowage compartment between rear seat cushions (3).	Model 209.4 except code (810) Sound system
4.2	Remove bass module speaker	Model 209.4 with code (810) Sound system	AR82.62-P-7839QA
5	Unclip door sill molding (4) and remove
6	Remove belt end fitting (5) from bottom B-pillar
7	Remove edge protection in bottom area of side paneling
8	Unclip side paneling in bottom rear (6)	Installation:  Replace clips.
9	Remove air ducts (7)
10	Route connection cable (8) through floor covering
11	Remove floor mat (9)
12	Install in reverse order