Fuel injection and ignition system (ME-SFI ) diagnosis diagnostic trouble code memory (Fault Codes P0100, P0105, P0110, P0115, P0120, P0130, P0133, P0135, P0136, P0141, P0170, P0201, P0202, P0203, P0204, P0243, P0300, P0301, P0302, P0303, P304, P0325, P0335, P0341, P0370, P0400, P0410, P0422, P0440, P0442, P0443, P0446, P0450, P0455, P0460, P500, P0507, P0560, P0565, P0600, P0604, P0605) - AD07.61-P-4000D
ENGINES 111.921 /942 as of 1.9.98, 111.943, 111.944 as of 1.8.96, 111.946 as of 1.6.98, 111.947 /973, 111.975 as of 1.8.96
fault codes P0000 to P0699
ENGINE 111.945 in MODELS 208.335 /435 as of 1.6.98, 202.020 /080 as of 1.9.98
fault codes P0000 to P0699
ENGINE 111.974
with CODE (494a) USA version
with CODE (807) Model year 1997
with CODE (808) Model year 1998
fault codes P0000 to P0699
| Hazard from contact with parts conducting high voltages. | Do not touch parts which conduct high voltages. Persons who wear electronic implants (e.g. heart pacemakers) must not carry out work on the ignition system. | AS15.10-Z-0001-01A | |
| Lethal Hazard from being drawn into rotating vehicle parts | Do not reach into rotating parts. Wear closed and close-fitting work clothes. Secure area of rotating vehicle components against unauthorized access. |
AS00.00-Z-0004-01A | |
| Risk of explosion from fuel igniting, risk of poisoning from inhaling and swallowing fuel as well as risk of injury to eyes and skin from contact with fuel. | No fire, sparks, naked flames or smoking. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing when handling fuel. |
AS47.00-Z-0001-01A | |
| Fuel injection and ignition system (ME-SFI ) diagnosis contents | M111.943/946 as of 6/98, M111.973 in model 170. M111.944 as of 8/96 in model 202, M111.974 in model 202 M111.975 as of 8/96 in model 202.024, M111.975 in model 202.085. M111.944/975 in model 208, M111.945 as of 6/98 in model 208.335, M111.945 in model 208.435. M111.947 in model 210 |
||
| Check and adjust engine | Engine diagnosis manual, index B | ||
| Fuel injection and ignition system (ME-SFI ) diagnosis previous knowledge | AD07.61-P-2000D | ||
| The fault code cannot be read out with the pulse counter | |||
| ■ Symbol for exhaust-related faults that lead to actuation of CHECK ENGINE malfunction indicator lamp in USA vehicles. Lamp is not actuated until tests have been performed and faults have been detected | |||
| a | Connect hand-held tester (HHT), read out diagnostic trouble code memory | Models 124.034/036, models 129.058/063/067/076 | AD00.00-P-2000-03A |
| Models 140, 170, 202, 208, 210 | AD00.00-P-2000-03B | ||
| Model 124 except 124.034/036, Models 129.060/061/066, model 201 | |||
| b | Ignition ON | ||
| Diagnostic trouble code memory: | |||
| Error code |
Possible cause | Note | Remedy |
| No fault recognized | Depending on nature of complaint, perform full ME-SFI electrical test | AD07.61-P-6000D AD07.61-P-6001D AD07.61-P-6002D |
|
| 111.921 as of 1.9.98, 111.942 with manual transmission as of 1.8.99, 111.942 with aut. transmission as of 1.9.98, 111.944 with aut. transmission as of 1.6.98, 111.945 with manual transmission as of 1.8.99, 111.945 with aut. transmission as of 1.9.98 |
AD07.61-P-6003C | ||
| 111.946 with aut. transmission as of 1.6.98, 111.947 with manual transmission as of 1.8.99, 111.947 with aut. transmission as of 1.6.98, 111.973 with aut. transmission as of 1.6.97, 111.975 with manual transmission as of 1.8.99, 111.975 with aut. transmission as of 1.6.97, |
AD07.61-P-6004A | ||
| 111.921 /942 up to 31.8.98, 111.943, 111.944 /946 /947 up to 31.5.98, 111.973 up to 31.5.97, 111.945 up to 31.8.98 |
|||
| 111.974 with CODE (807) model year 1997 with CODE (808) model year 1998 |
|||
| P0100 ■ | Hot film mass air flow sensor (B2/5) | AD07.61-P-6000-04D | |
| P0105 ■ | Pressure sensor (B28) | AD07.61-P-6000-06C | |
| P0110 ■ | Intake air temperature sensor (in hot film mass air flow sensor B2/5) | AD07.61-P-6000-05A | |
| P0115 ■ | Coolant temperature sensor (B11/4) | AD07.61-P-6000-08A | |
| P0120 ■ | Actual value potentiometer in actuator | AD07.61-P-6002-03B | |
| P0130 ■ | A: O2 sensor upstream of catalytic converter (G3/2) | AD07.61-P-6000-42A | |
| B: O2 sensor upstream of catalytic converter (G3/2) voltage increase too low | |||
| P0133 ■ | A: O2 sensor upstream of catalytic converter (G3/2) aging correction value exceeded | AD07.61-P-6000-42A | |
| B: O2 sensor upstream of catalytic converter (G3/2) aging cycle duration too long | |||
| P0135 ■ | O2 sensor heating of O2 sensor upstream of catalytic converter (G3/2) | AD07.61-P-6000-43A | |
| P0136 ■ | O2 sensor downstream of catalytic converter (G3/1) | AD07.61-P-6000-44A | |
| P0141 ■ | O2 sensor heating of O2 sensor downstream of catalytic converter (G3/1) | AD07.61-P-6000-45A | |
| P0170 ■ | A: Self-adaptation of "partial load" mixture formation to ME-SFI control module (N3/10) limit | Unmetered air, fuel injector diaphragm-type pressure regulating valves, engine wear | |
| B: Self-adaptation of "idle speed" mixture formation to ME-SFI control module (N3/10) limit | |||
| P0201 ■ | Fuel injector (Y62y1) Cylinder 1 |
AD07.61-P-6000-18C | |
| P0202 ■ | Fuel injector (Y62y2) Cylinder 2: |
AD07.61-P-6000-19D | |
| P0203 ■ | Fuel injector (Y62y3) Cylinder 3: |
AD07.61-P-6000-20D | |
| P0204 ■ | Fuel injector (Y62y4) Cylinder 4 |
AD07.61-P-6000-21D | |
| P0243 | Recirculated air flap actuator (M16/7) for compressor (causal chain, measured using air mass) | Compressor | AD07.61-P-6000-55A |
| P0300 ■ | A: Misfire B: "Catalytic converter-damaging" misfire |
AD07.61-P-6001-11C AD07.61-P-6001-12D AD07.61-P-6001-17D AD07.61-P-7002-02A AD07.61-P-7002-03A Compression pressure |
|
| P0301 ■ | A: Cylinder 1 misfire B: "Catalytic converter-damaging" cylinder 1 misfire |
AD07.61-P-6001-17D AD07.61-P-6001-11C AD07.61-P-7002-02A AD07.61-P-7002-03A Compression pressure |
|
| P0302 ■ | A: Cylinder 2 misfire B: "Catalytic converter-damaging" cylinder 2 misfire |
AD07.61-P-6001-17D AD07.61-P-6001-12D AD07.61-P-7002-02A AD07.61-P-7002-03A Compression pressure |
|
| P0303 ■ | A: Cylinder 3 misfire B: "Catalytic converter-damaging" cylinder 3 misfire |
AD07.61-P-6001-17D AD07.61-P-6001-12D AD07.61-P-7002-02A AD07.61-P-7002-03A Compression pressure |
|
| P0304 ■ | A: Cylinder 4 misfire B: "Catalytic converter-damaging" cylinder 4 misfire |
AD07.61-P-6001-11C AD07.61-P-6001-17D AD07.61-P-7002-02A AD07.61-P-7002-03A Compression pressure |
|
| P0325 | Knock sensor | Cable connector Knock sensor |
|
| P0335 ■ | Crankshaft position sensor (L5) | AD07.61-P-6001-09D | |
| P0341 ■ | Camshaft Hall sensor (B6/1) | AD07.61-P-6001-10D | |
| P0370 ■ | Camshaft to crankshaft angle difference | Inspect basic position of camshaft | |
| P0400 ■ | Exhaust gas recirculation malfunction (causal chain) | 111.974 |
AD07.61-P-6000-51A |
| 111.974 |
AD07.61-P-6000-52A | ||
| P0410 ■ | Secondary air injection malfunction (causal chain) | Model 202 Model 170 |
AD07.61-P-6000-26C |
| P0422 ■ | Too little catalytic converter effect | Three-way catalytic converter | |
| P0440 ■ | System purge leaking (causal chain) | AD07.61-P-6000-29C AD07.61-P-6000-30C |
|
| Model 170 Model 202 |
AD07.61-P-6000-31C | ||
| P0441 ■ | Purge not working | AD07.61-P-6000-29C AD07.61-P-6000-30C |
|
| P0442 ■ | Slight leak in system purge | Model 170 Model 202 |
AD07.61-P-6000-31C |
| P0443 ■ | Purge control valve (Y58/1) | AD07.61-P-6000-29C | |
| P0446 ■ | A Activated charcoal canister shut-off valve (causal chain) | AD07.61-P-6000-30C | |
| Model 170 |
AD07.61-P-6000-31C | ||
| Model 202 |
|||
| Model 170 |
AD07.61-P-6000-33C | ||
| B: Activated charcoal canister shut-off valve (Y58/4) | Model 202 |
||
| Model 170 |
AD07.61-P-6000-32C | ||
| Model 202 |
|||
| P0450 ■ | A: Fuel tank pressure sensor (B4/3) electrical fault B: Fuel tank pressure sensor (B4/3) electrical fluctuations |
Model 170 Model 202 |
AD07.61-P-6000-33C Activated charcoal canister blocked |
| Purge monitor pressure sensor (B4/4) | 111.921/944/945/974/975 up to 31.8.97 |
AD07.61-P-6000-48B | |
| P0455 ■ | Bad leak in system purge or Fuel tank pressure sensor | Model 170 Model 202 |
AD07.61-P-6000-31C |
| Model 170 Model 202 |
AD07.61-P-6000-33C | ||
| P0460 | Fuel gauge sensor | Model 170 Model 202 |
Read out ICI |
| P0500 | A: Left front vehicle speed signal B: Left rear vehicle speed signal |
Model 210 as of 06/96 with CODE 212a | AD42.00-P-4000A |
| Model 210 as of 06/96 with CODE 471a | AD42.00-P-4000A | ||
| Model 210 as of 06/99 with CODE 472a | AD42.45-P-4000A | ||
| P0507 | Idle speed control | AD07.61-P-6002-08A AD07.61-P-6002-09A AD07.61-P-6002-03B |
|
| P0560 | Voltage supply to ME-SFI control module (N3/10) | AD07.61-P-6000-01D AD07.61-P-6000-02D |
|
| P0565 | Variable cruise control push-button switch (S40/4) | AD07.61-P-6003-01C | |
| P0600 | CAN from ESP | AD07.61-P-6000-34C | |
| P0604 | A: ME-SFI control module (N3/10) B: ME-SFI control module (N3/10) |
N3/10 | |
| P0605 | ME-SFI control module (N3/10) | N3/10 |