Retrofit hotel lock (90° position). - AZ88.50-P-0003P

MODEL 203.0 

Shown with trunk lid handle removed 

Fig 1: Retrofitting Hotel Lock (90° Position)

	Remove
1	Remove side paneling in left trunk
			AR68.30-P-4600P
2	Remove rear SAM control unit with fuse and relay box	Do not disconnect electrical connectors.
			AR54.21-P-1259P
3	Remove paneling from trunk lid
			AR68.30-P-8150P
4	Remove trunk lid handle	Removal see: ↓
		Remove/install trunk lid lock and locking and adjust.	AR88.50-P-5020P
5	Remove trunk lid lock cylinder
			AR88.50-P-5061P
	Install
6	Machine trunk lid lock		AZ88.50-P-0003-01P
7	Retrofit hotel lock wiring harness		AZ88.50-P-0003-02P
		Wiring harness repair set	Figure
8	Enter special equipment on vehicle data card and in vehicle online data card by hand
9	Install remaining parts onto vehicle	Steps 5 up to 1.
10	Carry out function check

Fig 2: Identifying Wiring Harness Repair Kit (220 589 02 99 00)

PARTS ORDERING NOTES

Part no.	Designation	Quantity
A032 545 19 28	Connector, 2-pin	1
A005 545 75 26	Contact spring	3
A203 821 75 51	Trunk lid contact switch (S88/6)	1
Commercially available	Round terminal (ground)	1
Commercially available	Brown line: 0.5 mm2 , length: 2300 mm	1
Commercially available	Yellow line: 0.5 mm2 , length: 2700 mm	1