Travel time, function - GF54.50-P-2004GH

MODEL 163 with CODE (245) Trip computer 

• The travel time runs from the starter switch (S2) in position "1" (Terminal 15R).
• The travel time continues running in the background even if the trip computer is in another operating mode, e.g. "momentary fuel consumption".
• The travel time can be stopped by briefly pressing (<2 seconds) the reset button. Pressing the reset button again (<2 seconds) allows the display to continue running. (At the same time the trip computer must be in travel time operating mode).
• The travel time stops when the starter switch is in position "0". The value displayed last is retained in the memory. If starter switch (S2) is turned back to position "1", the travel time continues to run starting from the stored value.

  There is no automatic reset.

• Reset 

  If the display is set to 00:00 (Reset), the reset button should be held down for 2 seconds

  Then press the reset button again to start a new interval. (Spalte 2)

  Fig 1: Identifying TRIP Computer Display - Travel Time

  
• Low voltage 

  After a low voltage, e.g. after the battery has been disconnected, the display reads 00:00.

  Function of trip computer (TRIP)

  GF54.50-P-0001GH