 |
Notes on self-locking nuts and bolts |
|
AH00.00-N-0001-01A |
| 1 |
Raise vehicle with lifting platform |
|
AR00.60-P-1000T |
| 2 |
Remove crossmember (35) |
 |
*BA62.30-P-1001-01A |
| 3 |
Detach heat shields (105d, 105e) and slide back or remove |
Depending on accessibility |
|
| 4 |
Preload automatic slack adjuster (91) |
|
AR42.20-P-0520-01A |
| 5 |
Detach front brake cable (85) at automatic cable slack adjuster (91) |
 Installation:
to attach front brake cable (85): ↓ |
|
| |
|
Pre-tension automatic cable slack adjuster (91) again. |
AR42.20-P-0520-01A |
| |
|
Installation:
after attaching front brake cable (85): ↓ |
|
| |
|
Slacken automatic cable slack adjuster (91) |
AR42.20-P-0520-02A |
| 6 |
Remove left cover below instrument panel |
|
AR68.10-P-1500T |
| 7 |
Remove side paneling (1) in left front footwell |
|
|
| 8 |
Detach front cover (76) of pedal assembly (71) |
|
|
| 9 |
Unlock and disconnect electrical connector on parking brake indicator switch (S12) |
|
|
| 10 |
Unscrew bolts (72) and take off pedal assembly (71) |
|
*BA42.20-P-1001-01A |
 |
Friction brake of parking brake pedal assembly, function |
|
GF42.20-P-1000A |
| 11 |
Take off rear cover (77) from pedal assembly (71) |
|
|
| 12 |
Detach front brake cable (85) from tensioning shackle (85a) |
Installation:
Pay attention to the correct position of the rubber ring (85b) in the tensioning shackle (85a). |
|
| 13 |
Unclip front brake cable (85) from pedal assembly (71) |
 |
Fig 2 |
| 14 |
Detach unlocking cable (79) from tensioning shackle (79a) |
|
|
| 15 |
Unclip unlocking cable (79) from pedal assembly (71) with tool for unlocking cable |
|
|
 |
Tool for releasing parking brake control cable |
|
WF58.50-P-4220-01A |
| 16 |
Install in the reverse order |
|
|
 |
Checking |
|
|
| 17 |
Check pedal travel at parking brake pedal (75); adjust parking brake if necessary |
|
AR42.20-P-0540T |