Remove/install guide tube for tilting/sliding roof control cable - AR77.20-P-1410GR

MODEL 463.222 /236 /237 /243 /244 /245 /246 /247 /248 /249 /270 /271 /322 /323 /332 /333 /336 /340 /341 /346 with CODE (D27) Power tilting/sliding roof 

Fig 1: Identifying Guide Tube, Pipe Clamp And Antenna Module

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Guide Tube And Tilting/Sliding Roof Frame

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Pipe Clamp

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Guide Tube, Transmission, Collar & Groove

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove luggage compartment cover	Only with code (V53) stowage box and luggage compartment cover and code (V57) luggage compartment cover:
2	Remove stowage box	Only on model 463.222/244/247/322/332/336/340 with code (V53) Stowage box and luggage compartment cover Only on left side.	AR68.72-P-0010GK
3	Remove trim from rear pillar	Only on left side.	AR68.30-P-4505GK
4	Remove paneling from tilting/sliding roof		AR77.20-P-0500G
5	Remove cable		AR77.20-P-1400A
6	Remove side wall lining	Only on left side.
		Model 463.243/245/246/249/323/333 up to 31.5.04 Model 463.248 up to 31.5.04 except code (979) Special protection version	AR68.30-P-1450GN
		Model 463.222/244/ 247/322/332/336/340 Station wagon, wheelbase of 2400 mm	AR68.30-P-1450GM
		Model 463.243/245/246/249/323/ 333 as of 1.6.04 Model 463.237/270/271/341/346 Model 463.248 as of 1.6.04 except code (979) Special protection version Model 463.236 except code (979) Special protection version	AR68.30-P-1450GX
7	Remove headliner	Except model 463.236/248 with code (979) Special protection version	AR68.30-P-4300GR
		Model 463.236/248 with code (979) Special protection version	AR68.30-P-4300PM
8	Remove antenna module (A2/51)	Only on left side.
		Except model 463.236 with code (979) special protection version.	AR82.62-P-8310GR
		MODEL 463.236 with CODE (979) Special protection version	AR82.62-P-8310PM
9	Unscrew guide tube (3) from tilting/sliding roof frame (5)
10	Unscrew pipe clamp (4) from left rear pillar
11	Remove guide tube (3) from tilting/sliding roof motor (M12/1m1) (arrow)	Installation:  When installing, ensure that the collar (7) on the guide tube (3) slides into the groove (8) on the gear (6).
12	Remove guide tube (3)	Installation:  The guide tube (3) for the operating cable should not be bent when installing, otherwise the operating cable will stick.
13	Install in the reverse order
14	Carry out function check