Remove/install soft top actuation hydraulic cylinder - AR77.37-P-4171QA
MODEL 209.4
| Remove/install | |||
|---|---|---|---|
| Risk of injury when performing check and repair work in area of roll bar | Before working in the area of the roll bar, pull out the rear head restraints by hand. Keep body parts out of the area where the roll bar extends. | AS91.00-Z-0003-01QA | |
| Risk of injury caused by moving parts that can pinch, crush or , in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating range of the mechanism when components are in motion. | AS00.00-Z-0009-01A | |
| Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure. Risk of poisoning from swallowing hydraulic fluid. | Depressurize the hydraulic system completely before starting any work on the system. Wear protective clothing and safety glasses. | AS00.00-Z-0013-01A | |
| 1 | Remove rear seat and rear seat backrest | AR91.12-P-1700QA | |
| 2 | Remove left or right side paneling in rear | AR68.30-P-4780QA | |
| 3 | Loosen sidebag unit in rear and lay down to side with electrical line connected | Only on vehicles with code (293) right and left rear sidebag. | AR91.60-P-0694QA |
| 4 | Partially close soft top | ||
| 5 | Cover vehicle in rear area | ||
| 6 | Expose hydraulic lines (6) and (7) | ||
| 7 | Remove retainer (2) from bolt (1). | ||
| 8 | Pull out pin (1) | ||
| 9 | Remove retainer (4) from pin (3) | ||
| 10 | Pull out pin (3) | ||
| 11 | Remove hydraulic cylinder (5) with hydraulic lines (6, 7) connected and lay down to side | ||
| 12 | Remove locking plates (8) from hydraulic lines (6) and (7) | ||
| 13 | Pull hydraulic lines (6) and (7) out of hydraulic cylinder (5). | ||
| 14 | Remove old sealing rings (9) from hydraulic cylinder (5) | ||
| 15 | Slide new sealing rings (10) onto hydraulic line (6, 7). | ||
| Hydraulic fluids (Sheet 343.0) | BB00.40-P-0343-00A | ||
| 16 | Install in the reverse order | ||
| 17 | Check oil level of hydraulic line, correct if necessary | ||
| Hydraulic fluids (Specification 343.0) | BB00.40-P-0343-00A | ||
| *BA77.37-P-1003-01C | |||
| Figure | |||
SOFT TOP -HYDRAULICS
| Number | Designation | Model 209.4 | ||
|---|---|---|---|---|
| BA77.37-P-1003-01C | Oil filler screw to hydraulic unit reservoir | Nm | 2 | |