Remove/install rear door - AR72.12-P-0600GN

MODEL 463.243/245/246/249/270/271/323/333/341 

MODEL 463.248 except CODE (979) Special protection version 

MODEL 463.237/346 up to model year 2013/model refinement package 2012 

MODEL 463.236 except CODE (979) Special protection version up to model year 2013/facelift 2012 

Fig 1: Identifying Rear Door Electrical Connector, Rubber Grommet And Screws

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Activate service mode in Telematic Alarm Identification on Demand (emergency call system) (TELE AID)	Only on model 463.243/244/245/250/309/322/323/332/333 with code (ET2) TELE AID car telephone emergency call system, 463.247/248/254/270 up to 1.4.07 with code (ET2) TELE AID car telephone emergency call system	AR82.95-P-0005-03GR
	Notes regarding the TELE AID emergency call system	Model 463.243/244/245/250/309/322/323/332/333, Model 463.247/248/254/270 up to 1.4.07	AH82.95-P-0001-01GA
	Risk of explosion  caused by escaping oxyhydrogen gas. Risk of injury  caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn  injuries caused by short circuit. Risk of poisoning  caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices	No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only pour liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers.	AS54.10-Z-0001-01A
2	Disconnect battery ground line		AR54.10-P-0003G
	Notes on battery	All models	AH54.10-P-0001-01A
3	Remove rear door lining		AR72.12-P-1010GN
4	Disconnect electrical connector from wiring harness on speaker
5	Remove rear door control unit		AR72.29-P-1100GN
6	Carefully loosen door foil	Installation:  Check door foil, replace if necessary, otherwise moisture can penetrate into the passenger compartment.
7	Loosen wiring harness from brackets and disconnect electrical connections (1)	Installation:  Ensure correct routing and mounting of the wiring harness.
8	Pull rubber grommet (2) out of door pillar and rear door	Installation:  Pay attention to the correct seat of the rubber grommet (2).
9	Pull electric leads out of rear door
10	Remove bolts (4) securing the lower door hinge.	Support front door to prevent damaging rear door or B-pillar.
11	Remove the screws (3) securing the upper door hinge.	Support rear door with aid of second person, otherwise rear door can fall down.
12	Remove rear door
13	Install in the reverse order
14	Adjust rear door		AR72.12-P-0650A
15	Deactivate service mode in Telematic Alarm Identification on Demand	Only on model 463.243/244/245/250/309/322/323/332/333 with code (ET2) TELE AID car telephone emergency call system, 463.247/248/254/270 up to 1.4.07 with code (ET2) TELE AID car telephone emergency call system	AR82.95-P-0005-03GR
	Notes regarding the TELE AID emergency call system	Model 463.243/244/245/250/309/322/323/332/333, Model 463.247/248/254/270 up to 1.4.07	AH82.95-P-0001-01GA
16	Read out fault memory and erase	STAR DIAGNOSIS Stored faults which can result from cables being disconnected or from simulation during removal and installation or test work, have to be processed and erased in the fault memories after completing the work.
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04A
17	Perform basic programming		AR00.19-P-0200P