Remove/install paneling on A-pillar - AR68.30-P-4050Q

WARNING: This page is about a different car, the 2009 Mercedes-Benz CLK350 and 2008 Mercedes-Benz CLK350. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 209

Fig 1: Identifying Trim And Edge Guard

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Note on function reliability of windowbag		AH91.60-P-0693-01A
1.1	Remove paneling from windshield at top	Model 209.4	AR68.30-P-4250QA
2	Pry off paneling (1)	Bring mounting wedge near the clamps (arrows) and pry off paneling (1).
2	Pry off paneling (1)		Figure
3	Remove trim panel (1)	Remove paneling (1) toward top out of the instrument panel guide.
4	Install in the reverse order
5	Align edge guard (2) after installation in area of paneling (1)

Fig 2: Identifying Wedge Tool (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA