Remove/install headlamp range controller - AR82.10-P-4000P

MODEL 203, 209 except CODE (614) Bi-xenon headlamp unit 

Fig 1: Identifying Headlamp Range Control Components - Model 203, 209 Except Code (614)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

MODIFICATION NOTES

24.5.06

"Disconnect/connect ground line on battery" removed

	Removing
1	Remove light switch module (S1)		AR54.25-P-3270P
2	Cut pneumatic lines (4)	Cut pneumatic lines (4) downstream of connections (2) to headlamp range controller (1).
	Install
3	Attach hoses (3) to connections (2) of headlamp range controller (1)	Use hoses (3) with an inside diameter of 3.5 mm.
4	Slide pneumatic lines (4) into hoses (3)	Pneumatic lines (4) must not be mixed up. Check against pneumatic lines (4) on old headlamp range controller (1).
5	Install light switch module (1)		AR54.25-P-3270P