Removing and installing wiper system - AR82.30-P-6400G: Notes

MODEL 170 

Fig 1: Identifying Wiper System Remove/Install Components (1 Of 2)

Fig 2: Identifying Wiper System Remove/Install Components (2 Of 2)

Modification notes

24.2.97

Adjusting windshield wiper added

Step 13

	Removal, installation
	Injury hazard  Windshield wiper mechanism can pinch, crush or, in extreme cases, even sever extremities	Always remove ignition key when working on windshield wiper mechanism.	AS82.30-Z-0001-01A
1	Withdraw ignition key
2	Remove wiper arms		AR82.30-P-6100G
3	Remove air inlet		AR83.25-P-1401G
4	Open cover on control module box
5	Disconnect wiper motor connector (B) from multi-function control module (N10- 3)	Removal: Unlock wiper motor connector (B) before disconnecting (arrow).
6	Pull rubber grommet (1) out of control module box (2)	Installation  : Ensure that rubber grommet (1) is seated properly.
N	Pull rubber grommet (3) out of water collector (4)	Installation  : Ensure that rubber grommet (3) is seated properly.
8	Remove water drain (5)
9	Unscrew screw (6)
10	Unscrew nuts (7, 8)
11	Remove wiper system (9)	Limited space, do not damage windshield.
12	Install in opposite order
13	Adjust wiper system		AR82.30-P-6400-01G
		Distance between wiper arm and wiper blade	*BE82.30-P-1002-01A
			Figure

Test and adjustment values, windshield wiper

Number	Designation			Model 170
BE82.30-P-1002-01A	Dimension	Distance "B" between wiper arm and wiper blade	mm	5
		See figure		AR82.30-P-6400-01G

Fig 3: Identifying Feeler Gauge (129 589 03 21 00)