Removing and installing air inlet - AR83.25-P-1401G

MODEL 170 

Fig 1: Identifying Air Inlet Remove/Install Components

	Removal, installation
1	Remove wiper arms		AR82.30-P-6100G
2	Unscrew 7 screws (1)
3	Remove cable strap (arrow) in center area
4	Lift air inlet
5	Separate coupling (2) of the washing nozzles
6	Separate electric connector (3) on the printed circuit board (4)	The printed circuit board is located at the air inlet on right side of vehicle.
N	Remove water hose and electric wiring through side opening at air inlet
8	Remove air inlet
9	Install in opposite order