  |
Removal, installation |
|
|
 |
Sealing joints following repairs |
Includes sealing joints on engine hood |
AR97.10-P-4000G |
|
Hollow cavity preservation following repair |
Includes hollow cavity preservation on engine hood |
AR97.20-P-1500G |
| 1 |
Open engine hood (1) and move to upright position |
|
AR88.40-P-1000G |
| 2 |
Unscrew bottom four bolts (4) in engine hood (1) |
 |
*BA88.40-P-1001-01A |
| |
|
The engine hood is held in place by the safety hooks on the engine hood hinges (5)
Installation
: Move bolts to coincide with pressure points in paint Ensure that engine hood fits correctly, if necessary ↓ |
|
| |
|
Adjust engine hood |
AR88.40-P-3020G |
| 3 |
Unclip retainer (2) and unhook gas pressure strut (3) from engine hood (1) at top |
|
|
| 4 |
Unscrew the two top bolts (4) in engine hood (1) |
Have second person secure engine hood |
*BA88.40-P-1001-01A |
| |
|
Installation
: Move bolts to coincide with impressions in paint |
|
| 5 |
Remove engine hood (1) with help of second person and set down on suitable surface |
Avoid damaging paintwork
Installation
: Position engine hood in safety hooks on engine hood hinges (5) |
|
| 6 |
Reinstall in opposite order |
|
|