Controlled heater operation, function - GF83.70-G-2004A

WARNING: This page does not describe the selected car, but rather 22 other vehicles, including the 2015 Mercedes-Benz G550, 2014 Mercedes-Benz G550, 2013 Mercedes-Benz G550, 2012 Mercedes-Benz G550, and 2011 Mercedes-Benz G550. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 463 as of 1.6.94 with CODE (H12) Stationary heater Webasto Tele Thermo Top S

Function prerequisites

Stationary heater started properly.

Function

The heater is controlled depending on the heat requirement. Three control states are possible depending on the heat requirement:

Heating in partial load mode
Heating in full load mode
Combustion pause

After the heater has started up it operates at full load. When the coolant temperature increases to above 79 °C, the control module switches over to the energy saving partial load mode.

If the coolant temperature drops to below 72 °C, the control module switches back to full load mode.

If the coolant temperature continues to increase in spite of switchover to partial load mode, the combustion pause with shut-off delay is started at 86 °C. After the coolant cools down to below 79 °C the heater starts up again in partial load mode.

If the heat requirement is greater than the maximum heating capacity, the stationary heater operates continuously in the full load mode.

Controlled heater operation is terminated by switching off, by termination of heater operation due a malfunction or after expiration of the maximum heating time of 60 min.

	Starting heater operation, function		GF83.70-G-2000A
	Termination of heater operation, function		GF83.70-G-2002A
	Interruption of heater operation, function		GF83.70-G-2005A
	Shut-off delay, function		GF83.70-G-3034A