LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2002 >> CLK430 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Suspension -- 208 Chassis >> Testing & Repair >> Remove/install engine mount - AR22.10-P-1100 >> Removing and installing engine mount - AR22.10-P-1100MV

Removing and installing engine mount - AR22.10-P-1100MV

ENGINE 113.943 in MODEL 208.370 /470 

ENGINE 113.984 in MODEL 208.374 

Fig 1: Identifying Engine Mount Remove/Install Components - Engine 113.943/984
G04728687
REMOVINGINSTALLING Remove/Install     
1 Remove engine compartment paneling   AR61.20-P-1105AB
2 Unscrew bolts (5) of the engine mount (3) at the front axle carrier TORQUE SPECIFICATION *BA22.10-P-1001-01L 
3 Remove engine trim panel IMPORTANT The air cleaner is integrated in the engine cover.
Pull the engine cover vertically upwards and detach it from the cylinder head covers.
 
4 Disconnect/connect battery's ground cable IMPORTANT Only necessary if the right engine mount is removed.
Installation:  After connecting, read fault memory, encode radio and normalize power windows.
Vehicles with stationary heater: adjust time display on stationary heater.
AR54.10-P-0003A
5 Remove viscous fan (1) IMPORTANT Right-hand thread! AR20.40-P-5660C
6 Remove hot film mass air flow sensor with air intake pipe   AR07.07-P-1454AG
7 Fit on engine supporting frame   AR33.10-P-0100-01AV
8 Raise engine NOTES Ensure that the rear of the engine does not touch the body!
Do not over-tension coolant hoses!
 
9 Unscrew bolts (2) of the engine mount (3) at the engine support TORQUE SPECIFICATION *BA22.10-P-1004-01L 
10 Remove shields (4) Installation: 
The recesses in the shields must be located in the anti-twist locks of the engine supports.
 
11 Remove engine mounts (3) Installation: 
NOTES The anti-twist locks (arrows) at the engine mounts (5) must be located in the retaining slots (arrows) of the engine supports.
 
IMPORTANT Environmental protection regulations for disposal of engine mounts Dispose engine mounts into mixed scrap.  
12 Install in the reverse order    
13 Read out fault memory and erase IMPORTANT Only necessary if the right engine mount is removed.
Stored faults which can result from cables being disconnected or from simulation during removal and installation or test work, have to be processed and erased in the fault memories after completing the work. ↓
 
    Diagnosis Manual Volume 2, Index 0: Connecting and using test equipment  
TORQUE SPECIFICATION ENGINE MOUNTS, ENGINE SUPPORTS

Number Designation Engine 112.940, 113.943/984 in model 208.365/370/374/465/470
BA22.10-P-1001-01L Bolt of front engine mounts to front axle carrier Nm 35
BA22.10-P-1004-01L Bolt of front engine mount to engine support Nm 55