Adjusting seal on sliding/pop-up roof cover - AR77.20-P-1360K

MODEL 208.3 

Fig 1: Identifying Seal On Sliding/Pop-Up Roof Cover Adjusting Components

	Adjustment
	If wind noises are present the seal (1) can be adjusted in relation to the sliding roof opening
1	Check adjustment of sliding/pop-up roof cover		AR77.20-P-1100K
2	Modify long wedge		WF58.50-P-1360-01K
3	Open sliding/pop-up roof cover or move to pop-up position
4	Adjust seal (1) with long wedge (3) or with roller (2)	To reduce gap:  Move seal (1) with long wedge (3) under pressure uniformly from bottom to top in joint between insert profile (4) and seal (1). Move long wedge at an angle to joint
		To increase gap:  Move roller (2) with little pressure on seal (1)
		To increase in area of radius:  Use a suitably rounded plastic wedge

Fig 2: Identifying Roller (168 589 05 63 00)