Remove/install fog lamp - AR82.10-P-5103P

MODEL 203 

Fig 1: Identifying Fog Lamp Remove/Install Components - Illustrated On Model 203.0

Illustrated on Model 203.0 

	Remove/Install
	Risk of death.  Death may result if vehicle slips or topples from the lifting platform.	Align vehicle between columns of lifting platform and position the four support plates below support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
1	Remove front fender liner in front fender		AR88.10-P-1300P
2	Remove connector from left (E5/1) and right (E5/2) fog lamps
3.1	Remove base and bulb	Only for left fog lamp (E5/1)
4.1	Unscrew screws (1)	Only for left fog lamp (E5/1)
			*BA88.20-P-1006-01A
			Fig 2
5	Unscrew bolt (2)
6.1	Push front bumper (3) forward using a suitable tool	Only for left fog lamp (E5/1)
		To avoid damaging the front bumper (3), push forward by no more than 1 cm.
7	Remove left (E5/1), right (E5/2) fog lamps	Installation:  Insert pilot studs into front bumper (3)
8	Install in the reverse order
9	Check headlamp and fog lamp settings, correct if necessary
	Check and correct headlamp adjustment		AP82.10-P-8260P

BUMPER

Number	Designation		Model 203
BA88.20-P-1006-01A	Bolt of front bumper to cross member	Nm	4

Fig 2: Identifying Torque Wrench (000 589 67 21 00)