Remove/install center high-mounted stop lamp - AR82.10-P-5375P

MODELS 203.0 

Shown on Model 203.0 

Fig 1: Identifying Center High-Mounted Stop Lamp Remove/Install Components - Shown On Model 203.0

	Remove
1	Remove paneling from inside of trunk	+Refer to: ↓
		Remove/install trunk lid	AR88.50-P-5000P
2	Undo bolts at retaining clamps (1) of center high-mounted stop lamp (E21)
3	Push center high-mounted stop lamp (E21) out of trunk lid
4	Unplug center high-mounted stop lamp connector
5	Remove retaining clamps (1)
	Install
6	Screw retaining clamps (1) to center high-mounted stop lamp (E21)	When replacing a center high-mounted stop lamp (E21) it is supplied with new retaining clamps (1).
7	Attach connector of center high-mounted stop lamp
8	Insert center high-mounted stop lamp(E21)	Check condition and correct seating of seal as otherwise moisture penetration may occur.
		Prevent retaining clamps from damaging paintwork (1).
		Ensure that retaining clamps (1) are correctly seated; the retaining clamps must be able to be pushed together when fitted.
9	Perform a function test
10	Install hazard warning triangle	Refer to: ↓
		Remove/install trunk lid	AR88.50-P-5000P