Remove, install additional turn signal lamp - AR82.25-P-4726P

MODEL 203 

Shown on model 203.0 

Fig 1: Identifying Additional Turn Signal Lamp Remove/Install Components - Shown On Model 203.0

	Removing, installing
1	Remove trim panel of exterior mirror (2)		AR88.70-P-9040P
2	Unscrew screws (1)
3	Take out turn signal lamp of left/right exterior mirror (E6/5, E6/6)	Installation:  Ensure that the turn signal lamp is correctly installed in the trim panel.
		Remove outside rearview mirror (2) from covering.
4	Install in the reverse order
5	Perform function check