Remove/install driver's side interior fuse box - AR54.15-P-1310P
MODEL 203
| Remove/install | |||
| Risk of explosion caused by oxyhydrogen gas. Risk of poisoning and caustic burns caused by swallowing battery acid. Risk of injury caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries | No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Only pour battery acid into suitable and appropriately marked containers. | AS54.10-Z-0001-01A | |
| 1 | Disconnect battery ground cable | AR54.10-P-0003P | |
| Notes on battery | All models | AH54.10-P-0001-01A | |
| 2 | Unclip side cover (1) (direction of arrow) and remove | ||
| 3 | Unplug fuses | ||
| Fuse assignment, as-built configuration | GF54.15-P-1256P | ||
| 4 | Remove bolts (2) | Fig 3 | |
| 5 | Remove interior fuse box (F34) | ||
| 6 | Unscrew nuts (3) | ||
| 7 | Take off cable of circuit 30 of interior fuse box (F34) | ||
| 8 | Release contact receptacles and pull out of interior fuse box (F34) | Note installed position of cables (mark for identification!). Ensure that the female contacts are correctly locked. |
Fig 2 |
| Disconnecting cables from control units and fuse and relay boxes. | AR54.18-P-1261-01PA | ||
| 9 | Install in the reverse order | ||
| Read out fault memory and erase | Stored faults possibly caused by previous simulation or by cables disconnected in the process of installation or testing must be processed and erased in the DTC memories once all work is completed. See: ↓ STAR DIAGNOSIS. |
||
| 10 | Render electrical system operational | See: ↓ | |
| Perform basic programming. | AR00.19-P-0200P |